Forum Replies Created
-
AuthorPosts
-
Prabakaran P MParticipant
It will not show you 3A when you measure, with the above circuit you can use any devices upto 3Amps.
June 26, 2016 at 7:49 am in reply to: Arduino interfaced with ESP8266 wifi module and 16*2 LCD #14007Prabakaran P MParticipantRefer the new articles on ESP8266 which will give you the different ways of getting your output.
Prabakaran P MParticipantRefer this link it may help you
http://www.engineersgarage.com/embedded/arduino/how-to-make-lcd-scrolling-display-using-arduino
Prabakaran P MParticipantThe working is all fine. Check the circuit block by block i.e check the DC/AC converter seperately with the battery supply, Module based testing may help you.
Prabakaran P MParticipantRefer the projects in Engineers garage which involves relay.
June 26, 2016 at 7:28 am in reply to: controller for detecting a digital input to RA0, RA1 & RA2 #14003Prabakaran P MParticipantIf your aim is to check the input only, you can use transformer less AC to DC circuit and then a optocoupler to detect the input.
Prabakaran P MParticipantCheck the Crystal connected to the PIC. Also check the Device configuration.
Prabakaran P MParticipantGPS module is to get the coordinates, you can transmit datas through GSM.
June 26, 2016 at 6:59 am in reply to: Controlling BLDC wirlessly using Arduino Uno at 433 MHz #14000Prabakaran P MParticipantThe range of 433MHz RF is less for a flight. Go for some high range RF modules.
Prabakaran P MParticipantYou can find you article in the Home page on the day it is published. Wait for the day of publishing.
Prabakaran P MParticipantYou can use Raspberry Pi to do this project
Prabakaran P MParticipantIf I'm getting u correctly, you want to store the current angle of the servo motor.
June 26, 2016 at 6:47 am in reply to: Fall Detection using Piezo Sensor and Receive an Alert via Text Message #13996Prabakaran P MParticipantTo send GSM msg you can refer this link
http://www.engineersgarage.com/embedded/arduino/how-send-message-gsm-module-using-arduino
You have 5 ADC ports in UNO so you can connect 5 sensors
Prabakaran P MParticipantAny PIC controller with sleep mode can do this and I suggest to have a PIC with inbuilt RTC.
Prabakaran P MParticipantThis error is may be due to Baud rate configuration, check the baud rates of both module and PIC.
-
AuthorPosts