- This topic has 3 replies, 2 voices, and was last updated 10 years, 6 months ago by .
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
|
Microcontroller › AVR › regarding interfacing of xbee to pc through max 232
sir,
there is a problem interfacing xbee to my pc through max 232. i have connected vcc, ground,tx,rx pin of xbee to max232 providing 3.3v..with reset button…but there is always some problem ..every time it is showing that…
if u tell me how we can check ouer xbee is properly working or not….
Hi Himanshu,
There must be some configurations you have to do with that software. Which is that software shown in the image actually?
sir ,
i am using x-ctu software from digi international. to configure xbee as a transmitter or reciever..
Hi Himanshu,
Most of the time there requires a 3.3V to 5V logic level circuit between the Xbee output and MAX232 input. It can be easily made with a single diode and resistor.