- This topic has 4 replies, 3 voices, and was last updated 8 years, 3 months ago by .
Viewing 5 posts - 1 through 5 (of 5 total)
Viewing 5 posts - 1 through 5 (of 5 total)
- You must be logged in to reply to this topic.
|
Hello everybody,
Would you please answer and help me
about the, cell phone controlled pick and place robot project on this site:
1.I use one mobile set as a transmitter to command to receiver(robot) that
connected into receiver circuit and one more mobile set at the receiver circuit(robot),
with two sim cards,is it true?
2.Would you please show and tell me that; exactly, where is the output of the mobile set
at the receiver side that should be connected as input into the receiver circuit(robot)?
3.I want to use a camera type mobile set at the both sides, transmitter and receiver(robot),
to send images from receiver(robot) to the transmitter(transmitter’s mobile set) whenever
I press a key or automatically on each call,would you please tell me how can do that?
4.I want to use all of the buttons on the transmitter’s mobile set and receiver’s or robot’s
mobile set to control more devices,would you please tell me how can do that?
Thanks,
Suggest you to take a detailed look at the circuit diagram, it is clearly written where to connect TIP pin from the mobile phone to the circuit. You can use all the buttons, but to perform an action accordingly, you need to write the required lines in the code.
the output is taken from 3.5 mm headphone – hands free output socket of cell phone.
sending and receiving camera images is completely different thing. it uses MMS service. and lot more other things are included
Hi,
With thanks to ALFRED and Bhatt;
I downloaded the circuit diagram but that is not clear!?
I mabnify it to see the diagram better but it gets dim
and non-obvious!!? How can get a better picture?
I do not mean the MMS services,but, in the case of
activating the MMS services by the authorized
communication company; How can I activate the
video and camera of a mobile by that recevier/robot (mobile) circuit?
Thanks,
what you are not getting in the circuit? pls specify