- This topic has 1 reply, 2 voices, and was last updated 13 years, 8 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.
|
Microcontroller › 8051 › How to interface ADC0808 using clock from 8051 microcontroller (AT89C51)
I have connected my adc0808 with at89c52 via 2 D flipflops… I wanted to provide the Vref voltage as an input to the adc . I have connected a pot to the Vref so that I can change the Vref value. I wanted to know what changes i have to make in the program and which channels to select?I have programmed in asm
Vref is just a referance voltage… is i make Vref as 3 volt then my adc will calibarated b/w 0 to 3 volt…
you canuse any channel… just go to the links:
how to use adc 0808…
http://www.engineersgarage.com/microcontroller/8051projects/interface-LDR-ADC0808-interrupt-clock-AT89C51-circuit
might be helpful for you since you wanted top design asm code…
http://www.engineersgarage.com/forums/8051/c-code-assembly-code