You are here: Home
you better use the mplab x ide which is made by netbeans…
you have to control the voltage input to the ac load that can be achived using triac…
for that you have to control triggering angle of the traic using pwm…
google on that u will find enough on that….
u have to elaborate what are u planning to do…
use the uart module to connect the microcontroller and zigbee module….
this header file works with all 8×51 series…
use the debugger to check weather the registers are getting right values or not….
pls let me know the principle u guys are using for controlloing ac motor….
weather its the voltage control or by frequency control…
u know that water level indicator works on the principle that salty water is a good conductor of electricity
but gasoline may get ignited if u use the same circuit……
its just the numer of machine cycles delay loop is wasting..