You are here: Home
thank u for u r reply
please post 18f4550 PIC simple led blinking program…
and how to connect the hardware connection….
please tell how to used inbuild usb data communication please shared the step for compiling inbuild usb
or
please share the coding
please,please ,help me …….
thanku for u r reply
i am interface Brushless DC Motor Driver
this is motor driver address details
I2C Address Selection
The default I2C address is 0x12. ADR2 shorted to GND will set the address to 0x14, ADR1
shorted to GND will set the address to 0x16, ADR1 and ADR2 shorted to GND will set the
address to 0x18. If the PPM signal is shorted to GND on start-up the driver will set the
addresses as 0x22, 0x24, 0x26 and 0x28 instead of 0x12, 0x14, 0x16 and 0x18. This allows for
an additional 4 address
i am using RtxTiny2 but not working any crack to use this