You are here: Home
Hi Ritesh,
I am using the same microcontroller P89V51RD2 in my MC kit , and I am using the “Flash Magic” software to burn/dump the hex file to MC . My Os is Windows 7. The software works fine even with Windows 8 release preview. What kind of an error are u getting. Please check once again whether u have selected the “P89V51RD2” in Select Device button , Baud rate – 9600, Interface- Non-ISP, in Flash Magic software and the specific COM port for your PC.
Check it out once again .. and if u get the error Post the error message.
Bye
Thanks Amrith for your suggestions, but I had tried it earlier it didn’t work. I found out the solution for this problm i.e :
1. Switch OFF the MC kit , connect it to the PC with serial cable .
2. (I am using “Flash magic” software to burn/dump hex file). Run the Flash magic software and Press start button to start burning the hex file.
3.When the software asks for “Reset the Device into ISP mode” , just Switch ON the MC kit.
4. This will flash/re-program the Mc kit , and Mc will start to work again normally.
And 1 more thing is that I had made some adjustments in the Flash magic Soft i.e : in Options – Advanced Options- Misc- I had tick marked “Disable signature Checking” and “Erase all Flash using Pages” buttons. I un-marked them after my Mc started working properly.