Forum Replies Created
-
AuthorPosts
-
eng wasParticipant
can you give my link for tutorial
eng wasParticipanti make call for interrupt and inside it i call function to display data while setting it show warrning ?
eng wasParticipantDear
the new code is fetch date and time from DS1307 once every seconds for few ms then display it in 7 segment for the rest of seconds but i notice a very simple blink in 7 segment
Why the led that indicate the PM not work ok i connect it to 74595 output as the 7 segmentKindly need help
eng wasParticipantDear
7 segment work OK now but the led that indicate the PM not work ok i connect it to 74595 output as the 7 segment
I need help on blinking two 7 segment and other stable when i adjust time or dateThanks
eng wasParticipantDears
I have also problem in the LED that display PM time it blinking
eng wasParticipantHi
I make a loop to do that, but in Proteus simulation i see simple blink in 7 segment every few seconds and see some number like 6 instead of 2, what can i do to get steady display
and if i use interrupts what can i do to make the 7 segment that what to adjust time in it blinking
i use 7 segment not LCD
Thanks
eng wasParticipantThanks AJISH ALFRED for reply
I use in main
DisplayTimeToSeg(Get_DS1307_RTC_Time());
DisplayDateOnSeg(Get_DS1307_RTC_Date());this take 130 ms
i understand from your reply that i make loop display the date and time and get the Time and date from DS1307 every 1 sec once so my question is that this 130 ms when i fetch the new time and date the 7 segment did not effect by this time
Thanks again
-
AuthorPosts