Forum Replies Created
-
AuthorPosts
-
Vara AshishkumarParticipant
Hi vraj,
Which controller do you used?
Vara AshishkumarParticipantHye vaibhav,
You should not change in circuit but some changes may be in code side.
Vara AshishkumarParticipantHye pradumna,
Which RFID module you used? It's very simple to interface if your RFID module supported UART connection. Just connect RX and TX pin of RFID reader to pin to TX and RX UART pin of PIC controller repectively.
March 17, 2016 at 12:03 pm in reply to: interfacing rfid with pic 18f4520 to operate relay as per rfid detection #13796Vara AshishkumarParticipantHye,
Describe your project in brief. Let me know do you know basic C programming and about PIC controller?
Vara AshishkumarParticipantHi Ashish,
We are provide only solution of your queries. Kinldly research on your project and do it. Post your query if you have face during project development.
Vara AshishkumarParticipantHi takkar,
Why you want to code in C# instead of in C?
Vara AshishkumarParticipantHi vishakhan,
Which kind of your project? If you want to simulation of only circuit , you can use circuitlab or any kind of simulation software. You can use proteus also. Proteus is helpful when your project build with controller.
Vara AshishkumarParticipantHi prathamesh,
Sim28 ml GPS module has inbuilt UART,SPI and I2C protocol. You can connect with raspberry pi using any one of them protocol.
Vara AshishkumarParticipantHi parikshit,
Describe your stuff in brief. So, we'll help to you.
Vara AshishkumarParticipantHye Pawlos,
Why you want to access of mobile in proteus? proteus is only simulation software.You should access peripheral like GSM with Serial terminal (by selecting COM port) in proteus. I am not sure but it should be not possible to access mobile in proteous.
Vara AshishkumarParticipantHi jayaseelan,
First refer the datasheet and pinout of tft touch screen and check once it is compatible with 8051 controller or not.
Which tft touch screen you are used?
Vara AshishkumarParticipantHi Vasanthkumar,
Refer the following link. It may be helpful you.
http://www.engineersgarage.com/embedded/pic-microcontroller-projects/gps-interface-circuit
Note: This link provide the information of gps interfacing with PIC18F4550. You can use this link as a reference.
March 2, 2016 at 12:13 pm in reply to: 7 segment based rtc ds1307 clock in c code by using 8051 #13743Vara AshishkumarParticipantHi karudaiyar,
The following link may be help you:
http://www.engineersgarage.com/contribution/real-time-clock-using-8051-microcontroller-rtc-ds1307
Vara AshishkumarParticipantHye Kitundu,
Thermistor act as resistance which is depends on temperature. Resistivity of thermistor is change when temperature is change. Output of thermistor is in voltage form (in mv) but it is not linear and changes also very small. We can increase the outpout of thermistor using OP-AMP.
Vara AshishkumarParticipantHye amit,
You can use EM-18 RF reader module for your application.
-
AuthorPosts