- This topic has 2 replies, 3 voices, and was last updated 8 years, 3 months ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
|
Microcontroller › 8051 › to increase the range for the Distance measurement using InfraRed sensor with 8051 by kishoretk22
Is there a way for us to increase the range for the Distance measurement using InfraRed sensor with ADC0804 & 8051 microcontroller (AT89C51) project provided in your website.It would be very helpful if u can provide us with the PCB layout for the new circuit as well as the old one.
Hi there
You would get optimum results only when the IR emitter is working under it's proper working conditions, like a proper voltage and current supply. So check out for the specifications of IR LED that you are using, you could get this in its datasheet. Then accordingly, decide the current limiting resistor value. These conditions would ensure that emitter works with recommended parameters and gives the maximium distance range possible.
Hope this helps
Good Luck
using IR sensor for distance measurement is improper way
use ultrasonic distance measurment (UDM) sensor instead