Microcontroller

[Rahul Mondol]

I have AT89C51 microcontroller……but i am unable to burn the microcontroller…i built hex file using keil software. Can u help me out which software i can use to burn AT89C51 microcontroller??

[Prabakaran P M]

Hi,

You can use WLpro software by willer which is commonly used. mostly it is based on the programmer you are using. Let me know the Programmer model so that i can give some suggestions. 

Note: if you are going to use WLPro software you have to install driver and make sure the port number should be less than 5.

[Rahul Mondol]

The model is 8051 Development board….with it there is a cd which contain keil and flash magic software….but flash magic is only for philips microcontroller……so i cannot burn AT89C51 in this development board.

[Ashutosh Bhatt]

if ur micro controller is AT89C51 then u have to buy any ATMEL programmer

[Rahul Tungar]

U need to buy 8051rd2 controller which has inbuild bootloader so u can use that with flashmagic

[Author]

Posts