- This topic has 2 replies, 3 voices, and was last updated 8 years, 1 month ago by .
Viewing 3 posts - 1 through 3 (of 3 total)
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.
|
Microcontroller › AVR › how to interface accelerometer output to CRO
HI
i have connected my adxl335 accelerometer to atmega 32 microcontroller. i want the output of this accelerometer to be displayed on CRO. HOW can i do that?
please do help.
thank you
Hi there
This particular type of accelerometer module gives analog voltage output corresponding to X, Y and Z axis' orientation. Its really simple to get these voltages over a CRO, just connect the positive part (red one) of CRO probe-wire with the output of module and make their ground common by connecting black part of CRO probe-wire to GND pin of module. After making some adjustments with the knobs, in CRO, you'll be able to see the analog voltage over the screen.
Good luck
if you want to see acclerometer output on CRO then why you need ATmega
you can directly see X Y Z outputs on multimeter or CRO?