- This topic has 2 replies, 2 voices, and was last updated 15 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
hii,
I am using usb programmer of avr. I am able to program the hex into atmega16 with it. recently i bought new atmega32 controller and i am not able to program it. i search a lot but i found there is need some hardware connection or in-built fuse setting. plz helps me.
if u r using USBASP programmer, so u have to program it at lower frequency because its fuse bit are configure at 1mhz internal oscillators.
u have short the jumper which make ur programmer to program at lower frequecy. u can set the fuse bit at 0xC9FF to config the controller at external high freq.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.