- This topic has 12 replies, 9 voices, and was last updated 7 years, 6 months ago by .
Viewing 13 posts - 1 through 13 (of 13 total)
Viewing 13 posts - 1 through 13 (of 13 total)
- You must be logged in to reply to this topic.
|
Microcontroller › 8051 › compiler for project “Clap counter using 8051 microcontroller (AT89C51)”
What is the compiler used for building this project??
The code for the project has been developed and built in Keil.
dear sir,
Thanks for your reply.
I successfully build this project and created hex file for it. But when I built this circuit to simulate in Proteus, no count were displayed. I provided pulse input into pin 39 instead of the signal from mic.
please give me the detail
please give me the detail
just get the setup file and you will get the instructions to install the software.
sir i am doing this clap counter. i have assembled the circuit. i am getting 5v at collector of 3rd transistor. when a sound is given it goes to 1v and again raises to 5v. but when i interface this to microcontroller 39 pin the 5v at collector is going to 0. but when i give direct 5v to 39th pin i am getting the count. but when kept at collector the potential goes to 0.3v. what would be the problem sir.
please reply as soon as possible
sir i want the ppt…..bcoz my seminar is at 4 july plz…….
Hi akshay,
Do you think this is a place where you can ask for a ppt?? Better you find some project centers nearby.
How this will work. will you please mention the detail about this.
Compiler is specific for clap counter ?
Hi Hafiz,
The clap counter mentioned here can be built without using a microcontroller. If there is no microcontroller there is no coding and no compilers.
can any body give me perfect ckt diagram and other detail
kindly send me its code