Currently I am in not in
Currently I am in not in India. Wish I was.
I will tell you exactly what I am going to do in my project.
I am going to make an inverter for powering the coil which will be used for induction cooking.
On the vessel used for cooking, I am going to put a temperature sensor , may be thermo couple or lm34 ar some other sensor.
The reading of the temperature sensor will be given to Analog to digital conveter.
Later I want to transmit that digital output to a receiver using RF communication.
The receiver will then send the output to a micro controller.
Micro controller will be used to control the output of the inverter depending on that received value from the sensor.
Consider an example .
If I am boiling water.
boiling temperature is 100 degree celcius.
Now my temperature sensor reads the temperature as 100 degree celcius. So I need to stop the power supply.
I want my sensor to give that data to the micrro controller so that micro controller will stop the inverter to give more power.
I want my micro controller to control the inverter’s output power depending on the temperature sensor’s output.
Is it possible ?